Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Setup drawing standards to show sheet and sector for detail and section view

Thread starter kscnoname
Start date Oct 5, 2016

Status: Not open for further replies.

Oct 5, 2016

kscnoname

Automotive

Hello,

does anybody know if it is possible to setup the NX (8.5) drawing standards to show sheet and sector information for detail and section views?

Thanks

Unigraphics Key user

V13, V14, V15, V16, V17, V18, NX, NX2, NX3, NX4, NX5, NX6, NX7.5, NX8, NX8.5, NX9