Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Settle-out pressure calculation
- Thread starter runsaep
- Start date
It's fairly simply - just build your spread of volumes vs pressures for each stage and then at the end of the sheet, you'll have a certain amount of gas and a certain amount of volume. Use the PVznrt rule to find the pressure - you can iterate on z or plug it into a simulator to get exact results. Heck, you could even assume z =1 for the first pass and see if this makes sense once you get the pressure.
- Status
Similar threads
- Locked
- Question