Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

setting up ANSYS120_DIR and ANSYS_SYSDIR?

Status
Not open for further replies.
edoardo777

edoardo777

Mechanical
Joined
Dec 1, 2007
Messages
11
Location
CH
dear all,

I am a newbie novice toward ANSYS (I will have to use 12.0) and I have to setup the system variables ANSYS120_DIR and ANSYS_SYSDIR.

Where should these variables should point at?

can somebody help me?

ciao
Edo
 
Status
Not open for further replies.

Similar threads

Ahmed_abdelgawad
  • Question Question
CDB and ‘prnsol,s’
Replies
0
Views
6K
Ahmed_abdelgawad
Ahmed_abdelgawad
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
V
  • Locked
  • Question Question
Boundary conditions and post processing for Planar tension test
Replies
0
Views
611
vsw
V
IJR
  • Locked
  • Question Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
2K
IJR
IJR
LIAM_7
  • Locked
  • Question Question
ANSYS and fatigue analysis
Replies
0
Views
451
LIAM_7
LIAM_7

Part and Inventory Search

Sponsor

Back
Top