I need to set boots/hikeups on rough grade lathes prior to undercutting for removal, replacement and compaction of a building pad. Other than setting the lenker rod to the proposed grade I'm confused about how to set the rod for the hikeups. Any suggestions on the best procedure?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Setting Boots With Laser
- Thread starter jafcon1
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question