Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
semitopping 1
- Thread starter luky
- Start date
-
1
- #2
diamondjim
Mechanical
You can change the od of a shaper cutter
or addendum of the rack in your calculation
to be the point of hob relief or change
in angle to produce the relief.
Then calculate the highest point of contact
that the rack or shaper will make in contact
with the part you are cutting. Often referred
to as the highest point of single tooth contact.
or addendum of the rack in your calculation
to be the point of hob relief or change
in angle to produce the relief.
Then calculate the highest point of contact
that the rack or shaper will make in contact
with the part you are cutting. Often referred
to as the highest point of single tooth contact.
- Status