Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Self reinforced nozzle hub thickness limitation
- Thread starter DK44
- Start date
The code has no limits.
That said, some customer specs will place limits on the hub thickness. I have seen specs that state requirements such as: hub thickness to shell thickness ratio shall not exceed 3:1. For vessels in cyclic service they shall not exceed 2:1. This is just an example...
That said, some customer specs will place limits on the hub thickness. I have seen specs that state requirements such as: hub thickness to shell thickness ratio shall not exceed 3:1. For vessels in cyclic service they shall not exceed 2:1. This is just an example...
- Status
Similar threads
- Locked
- Question