Does anyone find that they have a need to use the Inventor selection options such as; component offset, component size, sphere offset or selection by plane? I have been using Inventor now for a couple of years and have never used these commands and do not really see their value. Am I missing something? By my own admission there is alot of functionality that I do not take advantage of and perhaps this is one that I should.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Selection Sets
- Thread starter gmarken
- Start date
- Status