The Designer
Civil/Environmental
Is there a way to select a joint on Etabs by its Coordinates rather than Joint Label or unique name..
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Selecting Joints On CSI Etabs
- Thread starter The Designer
- Start date
- Status
- Thread starter
- #3
The Designer
Civil/Environmental
sometimes the modal functions don't run but there are no errors displayed when you check the model. one way to find the problem is to set the run on SAPfire solver then run the model... after the model is run there is a text file generated..
you can find the joints or lines causing the error in this text file...
the problem is that the label of the joints is usually wrong .. but the coordinates of the joints are written .. so i wanted to know if there is a way to select a joint by coordinates just to make it easier finding the joint ..
you can find the joints or lines causing the error in this text file...
the problem is that the label of the joints is usually wrong .. but the coordinates of the joints are written .. so i wanted to know if there is a way to select a joint by coordinates just to make it easier finding the joint ..
- Status
Similar threads
- Locked
- Question
- Locked
- Question