Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Selecting Edges throu shaded solids in NX4

Status
Not open for further replies.

LostDestiny

Mechanical
Joined
Nov 3, 2006
Messages
1
Location
CA
In NX3 it was possible to select edges, curves, etc. thru shaded solids without waiting for the QuickPick window. ( for exemple to create an extrude).
It looks like this option was removed in NX4 . It is still working in Wireframe view .

Is there any way in NX4 to have it back?


LostDestiny
 
If you select Edge/Curve from Selection Bar,it will work as NX3.

Michael.
 
It is also easier if your shaded view is somewhat translucent.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top