Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Section Views don't convert to ACAD
- Thread starter ryder001
- Start date
before converting drawings from autocad make sure that you do a select all and explode all.
It seems to help.
What version and SP are you using?
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
It seems to help.
What version and SP are you using?
Best Regards,
Jon
Challenges are what makes life interesting; overcoming them is what makes life meaningful.
- Thread starter
- #3
The problem exists converting from SolidWorks2004(SP4.1) to ACAD Mechanical 2005. The behaviour is erratic and unpredictable. Some sections convert, others don't. I have taken SW drawings that contain section views which convert successfully and made minor edits only to discover the sections no longer convert post-edit. I would then attempt to delete the edits that I made and the drawing will not convert even then.
- Status