M
medesign
Guest
Hi,
New to Solidworks 10 and I have a two part question.
I have a rectangle block with a hole thru the center. I want to cut it in half length wise and add a chamfer or funnel shape to the outside of the hole, after it has been sectioned. I thought of sectioning it again in a quarter then revolving the funnel on the quarter section but its only allowing me to work on one section at a time. The chamfer feature puts it on the outside of the rectangle. How do I section a drawing more than once?
Can you save a section view as an actual drawing to work and edit on just like any
.sldpart?
Edited by: medesign
New to Solidworks 10 and I have a two part question.
I have a rectangle block with a hole thru the center. I want to cut it in half length wise and add a chamfer or funnel shape to the outside of the hole, after it has been sectioned. I thought of sectioning it again in a quarter then revolving the funnel on the quarter section but its only allowing me to work on one section at a time. The chamfer feature puts it on the outside of the rectangle. How do I section a drawing more than once?
Can you save a section view as an actual drawing to work and edit on just like any
.sldpart?
Edited by: medesign
