scottylutz
Automotive
what happened to project section view in nx1919? I cant seem to find anything there now. it seems they have added "section line" but the old command of section view is not available.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
section view in nx1919?
- Thread starter scottylutz
- Start date
- Status
For me, it is next to the section line command (see screenshot). After installing NX 1919, I switched to the advanced role. If you do not see it in your ribbon, you might need to customize the UI to display it.
www.nxjournaling.com
www.nxjournaling.com
- Thread starter
- #4
scottylutz
Automotive
YA. THATS WHAT I USED TO HAVE. NOW I GET THIS IF I TRY TO LOADED IT UP. NOT AVAILABLE. SEE ATTACHED
There was a similar thread on the Siemens community site not long ago about the base view command missing (I can't find it now because their search is terrible). IIRC, the fix was something fairly easy such as deleting the user.mtx file and restarting NX. My memory is a bit hazy on it, though. You might consider contacting your reseller/GTAC to get their recommendation.
Edit: a Google search found it when their internal search couldn't seem to.
www.nxjournaling.com
Edit: a Google search found it when their internal search couldn't seem to.
www.nxjournaling.com
- Thread starter
- #6
scottylutz
Automotive
so, i have gone into my settings and cant find the trigger for this. others in my work group have the section view command but mine shows as unavailable in the command finder. where can i turn this on to make it available?
- Status