Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section I or VIII?

Status
Not open for further replies.
Welder4956

Welder4956

Materials
Joined
Apr 12, 2005
Messages
46
Location
US
What is the difference between a Safety Relief Valve manufactured to ASME I vs. ASME VIII as far as deign and function? This would be for steam service at pressure below 250 psi.
 
Sort by date Sort by votes
Welder,

You may want to try the "Boiler and Pressure Vessel Engineering" forum under Mechanical Engineering since you have no response here.

Good luck,
Latexman
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

KevinNZ
  • Locked
  • Question Question
Section XIII Nonmandatory Appendix B - N+1 devices
Replies
6
Views
1K
georgeverghese
georgeverghese
Nasim12345
  • Locked
  • Question Question
Set presure tolerance for PSVs- ASME Section 8, UG-134 D
Replies
2
Views
2K
JAlton
JAlton
Magnar
  • Locked
  • Question Question
Transport/shipping of new valves or after re-calibration
Replies
4
Views
2K
The Obturator
The Obturator
MAWPeter
  • Locked
  • Question Question
MAAP function of set pressure or MAWP?
Replies
3
Views
1K
georgeverghese
georgeverghese
Andrewg945
  • Locked
  • Question Question
I am working on a hydronic heating
Replies
9
Views
1K
Andrewg945
Andrewg945

Part and Inventory Search

Sponsor

Back
Top