Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

section designer

Status
Not open for further replies.
monchie

monchie

Structural
Joined
Feb 22, 2011
Messages
96
Location
IE
Hello,

In importing Steel I section,ie, UC 254x254x73 to section designer, Is there a way that you can view its name as "254x254x73", by clicking section properties in SD it only shows analysis/design/principal properties. Is there a way that I can view its name? Any ideas will be greatly appreciated
 
Status
Not open for further replies.

Similar threads

InnovatorX
  • Locked
  • Question Question
ETABS (22) API Section Cut Forces
Replies
3
Views
3K
sticksandtriangles
sticksandtriangles
alilemssefer
  • Locked
  • Question Question
section stress calculations ETABS
Replies
1
Views
339
alilemssefer
alilemssefer
sticksandtriangles
  • Locked
  • Question Question
ETABs API Troubles - Section Cut Definition
Replies
7
Views
1K
sticksandtriangles
sticksandtriangles
juandavidguzman
  • Locked
  • Question Question
None section property shell fail to transfer loads in ETABS 20.3
Replies
0
Views
243
juandavidguzman
juandavidguzman
Luis camposano
  • Locked
  • Question Question
SECTION DESIGNER THE ETABS HAS PROBLEMS WHEN DESIGNING SECTIONS WITH REINFORCEMENTS
Replies
2
Views
815
engineering_patrol
engineering_patrol

Part and Inventory Search

Sponsor

Back
Top