Hello to everybody...I am new in the forum...I've been working with sap2000 v11 one year now...I designed a column section in sap2000 section designer...An angle concrete column...I assign the section to the frames i want...When i start design/check of structure i get the message "error during check/design" of the particular frames...Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Section designer
- Thread starter geodou
- Start date
Similar threads
- Locked
- Question
- Locked
- Question