Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section designer

Status
Not open for further replies.
geodou

geodou

Civil/Environmental
Sep 11, 2008
10
Hello to everybody...I am new in the forum...I've been working with sap2000 v11 one year now...I designed a column section in sap2000 section designer...An angle concrete column...I assign the section to the frames i want...When i start design/check of structure i get the message "error during check/design" of the particular frames...Any suggestions?
 
Status
Not open for further replies.

Similar threads

a_urbs
  • Locked
  • Question
Using Section Cuts in SAP for Storey Weight
Replies
0
Views
1K
a_urbs
a_urbs
BVT
  • Locked
  • Question
Sap2000 Section Cut
Replies
0
Views
294
BVT
BVT
RK Sriwastav
  • Locked
  • Question
SAP2000 Section designer Issue 1
Replies
0
Views
197
RK Sriwastav
RK Sriwastav
Christopher Setiawan
  • Locked
  • Question
Section Area in Section Designer give smaller values than the actual section
Replies
1
Views
214
Blackstar123
Blackstar123
X4vier
  • Locked
  • Question
General Section - Are designed in SAP2000
Replies
1
Views
272
271828
271828

Part and Inventory Search

Sponsor

Back
Top Bottom