Section/Break Views not updating. 2

[Ripper2009]

Hi all.
Problem: have a shaft in SW drawing view - -
I did a break and now the section view is not auto updating with the break view.

Any suggestions?
Thanks in advance.

Thanks,

Rip


SolidWorks 2007
SP 4.0

 

[CorBlimeyLimey]

Do you mean Break View or Broken-out Section or Section View or a combination of these?

People have often posted problems with the first two.

 

[Heckler]

Have you tried doing a control-Q

Heckler
Sr. Mechanical Engineer
SWx 2007 SP 4.0 & Pro/E 2001

o
_`\(,_
(_)/ (_)

"Avoid the base hypocrisy of condemning in one man what you pass over in silence when committed by another." -- Theodor

 

[Ripper2009]

Thanks to all...person who had the prob started over..



Thanks,

Rip


SolidWorks 2007
SP 4.0

 

[CorBlimeyLimey]

So the problem was probably caused by the C2K interface.