Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Section 8 - UW

Status
Not open for further replies.
H Cameron

H Cameron

Mechanical
Joined
Sep 16, 2016
Messages
49
Location
CA
Hello,

I have pressure vessel as a pipe with two flanges at the ends. Pipe is seamless and flanges are WN. My understanding is it has to be designed based on UW part of Section 8. Am I in a right way?

Thank you for your guide.
 
Sort by date Sort by votes
It has to be designed using Part UG, UW and other pertinent parts based on material and service conditions.
 
Upvote 0 Downvote
metengr- LOL. Well put!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MchA
  • Locked
  • Question Question
Corner Joint Efficiency - UW-12
Replies
9
Views
7K
David3399
D
torsani
  • Locked
  • Question Question
Table UW-16.1 manufacture's fitting thickness
Replies
2
Views
2K
IdanPV
IdanPV
engineer121394
  • Question Question
Section modulus ratios
Replies
1
Views
6K
TGS4
TGS4
kremenco
  • Locked
  • Solved
Value of the angle alpha in fig UW-9-2
Replies
1
Views
1K
r6155
r6155
CrisDom
  • Locked
  • Question Question
UW-20 for U-tube HE
Replies
2
Views
722
CrisDom
CrisDom

Part and Inventory Search

Sponsor

Back
Top