Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SE femap Express modal analysis.

Status
Not open for further replies.
tumanek

tumanek

Mechanical
Joined
Jul 10, 2007
Messages
3
Location
GB
Hello!
Is possible to run modal analysis with teh frequency input? - another words is posible to find natural frequency in specified range? (for example between 10kHz-15kHz)?
Regards
tumanek
 
Sort by date Sort by votes
thanks - i have some experience in more advanced software. I need only answer -yes or no:)
regards
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

garmancm
  • Locked
  • Question Question
Create an "offset hem" or "countersunk lap seam" in SE with Sheet Metal
Replies
2
Views
507
kjoiner
kjoiner
garmancm
  • Locked
  • Question Question
Getting total count of parts selected
Replies
0
Views
478
garmancm
garmancm
ct27gt
  • Locked
  • Question Question
SE Folder Structure?
Replies
7
Views
370
ct27gt
ct27gt
ShaLad89
  • Locked
  • Question Question
SE ST7 shaded views in draft not printing in colour
Replies
4
Views
273
ShaLad89
ShaLad89
RSVMilleR
  • Locked
  • Question Question
SE Fastener system issue
Replies
5
Views
407
RSVMilleR
RSVMilleR

Part and Inventory Search

Sponsor

Back
Top