Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SDS shop data systems software good or bad?
- Thread starter JBurgess
- Start date
franklineng
Industrial
I haven't use SDS for punch/plasma programming, but I have used it for plasma and laser. It is not the best program available out there. The windows version is very difficult to program, the the dos verision was easlier. The nesting capabilties is limited.
You should check out Measurement Masters P.E.P.; it's expensive but an excellant program. The service center I worked for ungraded to a punch\plasma compiler after I had left the company. Previously used smartcam on a whitney plasma/punch.
You should check out Measurement Masters P.E.P.; it's expensive but an excellant program. The service center I worked for ungraded to a punch\plasma compiler after I had left the company. Previously used smartcam on a whitney plasma/punch.
- Status
Similar threads
- Locked
- Question
