Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Screw threads not lining up

  • Thread starter Thread starter DKScidmore
  • Start date Start date
D

DKScidmore

Guest
I am currently trying to screw a component into another component but each each I can step the screw through. I am looking for suggestions on how to close the gap. Below are the measurements.
the 1.64 is the outer shell of what I can screw into with the top being the female part.
Receiving End.jpgMale End.jpg
 
You must log in or register to reply here.

Similar threads

K
  • Question Question
ReplaceViewModel not working
Replies
16
Views
6K
koubaleite
K
C
Bends Will not flaten
Replies
0
Views
3K
Colinu
C
arb65912cmco
  • Locked
  • Question Question
I can not select face in patterned components in upper level assembly
Replies
1
Views
935
arb65912cmco
arb65912cmco
jdomechanical
  • Locked
  • Question Question
Trig equations in sketcher not evaluating properly
Replies
5
Views
663
jdomechanical
jdomechanical
Helepolis
  • Locked
  • Question Question
Display Pane Not Showing Sketch Colors
Replies
0
Views
303
Helepolis
Helepolis

Part and Inventory Search

Sponsor

Back
Top