When trying to open a SW assembly file in Photoview 360 I get an error message "Scene load was unsuccessful". I tried to open other files (part files also)...get the same message. I've not gotten this message before and have used Photoview 360 recently without this issue. Any help what could be the problem? Thank you.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Scene Load Unsuccessful Error in Photoview 360
- Thread starter toycept
- Start date
- Thread starter
- #3
Is it the same with every scene? If it is I'd try an instal repair. Sounds like SW forgot where the scenes are.
Dan
Dan's Blog
Dan
Dan's Blog
- Status