Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Scale Body Slider Scale

Status
Not open for further replies.

jerry1423

Mechanical
Joined
Aug 19, 2005
Messages
3,428
Location
US
Does anybody know if it is possible to change the range of the slider scale on SCALE BODY for a specific part ?
The Scale Factor currently slides from .02 to 2.2 and I would like it to go from .4 to 1.0

Capture_nxyh8p.jpg


Jerry J.
UGV5-NX1899
 
I don't know of any way to limit the slider values on a standard dialog. Failing that, you might look into adding a requirement on the resulting scale expression. NX should flag you when the expression value is out of the desired range.

www.nxjournaling.com
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top