Save failed in NX 7

[JerryLynch]

Hey guys,

I'm running NX7 with Teamcenter 2007 and I'm getting an error message when I save my assembly using 'Save Precise Assembly'. I get "While saving XYZ: XYZ - A duplicate file id was used" and the 'Modified' icon stays by my top level assembly. Any other edits that I've done to other parts within the assembly are saved just not the top level.

Other than moving to NX7.5 or 8 is there anything I can do about this?

Thanks

 

[looslib]

Run part cleanup on the top assembly.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli