Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SAP2000 v10 - Differences between "plane" and "Shell"

Status
Not open for further replies.

edferlac

Agricultural
Joined
Nov 21, 2005
Messages
4
Location
ES
Hi all.
I have a questions about a new area element implemented in v10 of SAP2000. It's the "plane" element.
Appears in the drop list, when selects area sections.
Where is the differencce between the shell elements -and variants - and this new area element?

Tanks
 
Hmmm... you must find the analysis reference manual (Saprefer.pdf). There you can read:

* * *

The Shell element is used to model shell, membrane, and plate behavior in planar and three-dimensional structures. The shell element/object is one type of area object. Depending on the type of section properties you assign to an area, the object
could also be used to model plane stress/strain and axisymmetric solid behavior.

* * *

The Plane ele ment is used to model plane-stress and plane-strain behavior in two-dimensional solids. The Plane element/object is one type of area object. Depending on the type of section properties you assign to an area, the object could also be used to model shell and axisymmetric solid be havior.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top