Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SAP to STAAD

  • Thread starter Thread starter -
  • Start date Start date
Status
Not open for further replies.

Guest
Anybody out there know of a translator that will take a SAP 2000 file and convert it into a STAAD file. I tried DXF, but that only has the geometry info. STAAD does not support CIS/2 so that is not an option. Has anybody written a translator of any type? Both use ASCII syntax so I am sure before all this CIS/2 somebody must have tried going back and forth.
 
Sort by date Sort by votes
I read that SAP2000 version 8.xx can export direct to
STAAD. And STAAD can import STEP file, too.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Blackfairy
  • Question Question
Pile Post design and modeling - using STAAD Pro to Allpile
Replies
0
Views
331
Blackfairy
Blackfairy
Althalus
  • Question Question
STAAD Feet vs Inches
Replies
4
Views
3K
dozer
dozer
CDLD
  • Question Question
Floor load error in STAAD Pro Connect
Replies
6
Views
7K
CDLD
CDLD
Michael Dee
  • Locked
  • Question Question
STAAD Warning Help
Replies
3
Views
810
BAretired
BAretired
Althalus
  • Locked
  • Question Question
STAAD Triangles
Replies
10
Views
957
TLHS
TLHS

Part and Inventory Search

Sponsor

Back
Top