Has anyone run into an issue where SAFE runs analysis/design and upon completion (can pan the model around for a moment) it decides to run the analysis and design again? I've got some models that take long enough to run a single time, and the glitchy extra run is really slowing the process down.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
SAFE Runs Analysis Twice
- Thread starter Luceid
- Start date
JoshPlumSE
Structural
There are design changes that can affect analysis results, right? Like if you add PT in some area then then that affects the stiffness of the slab in that area.
- Thread starter
- #3
That's a good point, however I'm not using any PT in this model, so I am just designing Rebar.
I know that Concept includes the rebar designed in its deflection calculations to some extent but I wasn't aware of SAFE doing a similar thing. Maybe that's what is going on.
I know that Concept includes the rebar designed in its deflection calculations to some extent but I wasn't aware of SAFE doing a similar thing. Maybe that's what is going on.
- Status
Similar threads
- Locked
- Question
