Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SAFE Punching shear design overwrites- Location type

Status
Not open for further replies.

S_P

Structural
Jan 16, 2020
1
Hi I'm trying to overwrite the location type of an interior column to be of "Corner" location type. I created a new model from an initial "Flat Slab" template with default settings but without drops, overwrote the location type of one of the interior columns location types to "Corner" and ran the analysis and design, however SAFE gives me a "N/C" error for punching design. Is this an error? Do I need to change other settings? Or is this not supported by SAFE? If so, when and for what can the Location-type overwrite be utilized?

Thanks,
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor