Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SACS

Status
Not open for further replies.
padeyedesigner

padeyedesigner

Structural
Joined
Jun 22, 2011
Messages
3
CAN ANYBODY TELL ME THE ANSWER FOR FOLLOWING ?

WHICH AREA'S TAKING FOR MAJOR AXIS SHEAR OF I SECTION IN SACS ANALYSIS SOFTWARE ?
WHETHER IS IT TAKING FULL TWO FLANGE AREA'S OF I SECTION ?

YOUR VALUABLE ANSWERS ARE HIGHLY APPRICIATED.

BY AYYAPPAN.
 
Sort by date Sort by votes
padeyedesigner,
Perhaps if you re-type your question in a more polite manner you may receive answers. Note "Bold" type is considered as shouting which is not acceptable!!!!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

adityabodhe86
  • Locked
  • Question Question
SACS OFFSHORE DESIGN
Replies
0
Views
107
adityabodhe86
adityabodhe86

Part and Inventory Search

Sponsor

Back
Top