Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SA 516 Gr70 Tube Sheet 2

Status
Not open for further replies.

ngapulone

Mechanical
Mar 25, 2013
2
Dear All,

I would like to confirm that is there any restriction for SA 516 Gr 70 to use Tube Sheet as per latest revision of ASME section VIII?
Now I need to use this material as tube sheet. But my ASME U stamp inspector suggest me to use forge material only.But because of other reason, I still want to use this SA 516 Gr 70.
When I checked in ASME section VIII, I could not find that this material should not be used tube sheet.If somebody know that there is any paragraph such a reason of I can't use it, please help me and tell which area I should find it. For me I need to firm the reason to talk with inspector. Thanks.
 
Replies continue below

Recommended for you

ngapulone,

Will you be welding on this tube sheet? I don't have a code book right in front of me but I do believe that Section VIII requires either a PT or MT around the outside peripheral edge of tube sheets constructed of plate material before and after welding - the NDE is to check for possible laminations in the plate material. Could this be what your inspector is concerned with? This wouldn't be a requirement if you were using a forging. Check the UW and UHX sections.
 
yes, I'll weld Tube sheet and shell. If so, I need to do NDE to raw material before drilling the tube holes. and NDE again to weldment after finish welding. Is it?
Thanks a lot numberfive.
 
You can use plate material such as SA-516 70 for tubesheet as long as client spec does not require forging only. If the tubesheet has hub, see Appendix 20 of the Code.
 
SA-516-70 is often used for tube sheets on ASME VIII exchangers. A forging is advised for heavy wall tubesheets for the reasons given by numberfive.
 
ngapulone, good idea to test for laminations before putting labor into the material. Re numberfive's point see UG-93(d)(3). Otherwise, plate is pretty widely used for tubesheets.

Regards,

Mike
 
HI heatexguy, where in the code does it list material restictions for TS?
 
Innovation2,

restriction on SA-105 as a tubesheet is specified in material specification SA-105 in SEction II Part A.

Nasir
Welding Engineer
DESCON ENGINEERING LIMITED
PAKISTAN
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor