PIPING_DESIGNER
Mechanical
Could you please help me !!!
How to model a rubber joint in caesar ii
How to model a rubber joint in caesar ii
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
rubber joint modeling in caesar ii
- Thread starter PIPING_DESIGNER
- Start date
- Status
If its an engineered product with known stiffness values, I'd define it as an expansion joint.
If it's essentially infinitely flexible compared to the piping (similar to braided hoses), I'd probably treat the two ends as unconnected and confirm the relative moment (expansion/contraction/offset) is acceptable per the cutsheet.
If it's essentially infinitely flexible compared to the piping (similar to braided hoses), I'd probably treat the two ends as unconnected and confirm the relative moment (expansion/contraction/offset) is acceptable per the cutsheet.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question