Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Routing mechanical

Thread starter ug2prog
Start date Apr 16, 2006

Status: Not open for further replies.

Apr 16, 2006

ug2prog

Mechanical

Hi

I am using routing module in our Unigraphics NX 2.0.6.2, MP 3. Its really strange sometimes my UG session quits without even any error message, when I try to modify the existing route, also when I remove stock from a subdivided segment.
Not only these, I cant even open that file again. My UG session disappears when I try to open that file.

Is there any maintenance pack released for this bug.
Suggestions and advice will be highly appriciated.

Thanks