Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Route Through Clip Icon Grayed Out

  • Thread starter Thread starter apnelson123
  • Start date Start date
A

apnelson123

Guest
In SW2015 I never had this problem. When try to create a route through my tube the Route Through Clip icon is grayed out regardless if i am editing the tube assembly, editing the tube route or in the main assembly. No matter where I am at it is the same.
 
You must log in or register to reply here.

Similar threads

CAD2015
  • Locked
  • Question Question
SolidWorks Routing Electrical - Stub management..............
Replies
3
Views
431
jassco
jassco
borsht
  • Locked
  • Question Question
Tolerancing grayed out on drawing when adding & modifying hole dimensions
Replies
1
Views
1K
SBaugh
SBaugh
ASIT859
  • Locked
  • Question Question
Tube Laser Part Modeling - Normal to Surface Cuts?
Replies
10
Views
1K
fraudster
fraudster
NiiBaa
  • Locked
  • Question Question
solidworks piping enable routing
Replies
4
Views
379
SBaugh
SBaugh
Ryan DelaCourt
  • Locked
  • Question Question
Straigtening out weldment members on Solidworks for cutting
Replies
3
Views
763
jassco
jassco

Part and Inventory Search

Sponsor

Back
Top