Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Roundness Check on Blow Molded Part

Status
Not open for further replies.

Klickal

Industrial
Joined
Feb 17, 2012
Messages
1
Location
US
Does anyone have any experience with roundness measuring equipment with regards to its uses on blow molded products?

Currently have a manual/mechanical device with an analog indicator gauge. Looking for a solution that accurately measures roundness of part while the user can walk away being productive and return with the data presented (automatically recorded data optional). Trying to steer away from the fancy ($$$) systems.

To add to the original question, has anyone here had that experience AND what have you had the best luck with in regards to part loading (in)consistencies, part warping, fixturing, etc.?

Any tips/suggestions/ideas would be greatly appreciated, thanks!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top