ROTATING .JPGs 1

[hotiron]

Hi all
Can an inserted .jpg be rotated in an assembly drawing other than increments of 90 degrees?

 

[CorBlimeyLimey]

If the image is the face of a part, you should be able to rotate it (using mates) by whatever angle you need. Or by dragging if the other DOFs are suitably constrained.

 

[hotiron]

CBL
Inserting the jpg files into a drawing does not allow any mating or manipulation other than that offered thru the paint toolbar. Here I can only flip the image, or rotate in increments of 90.

 

[CorBlimeyLimey]

You missed my point. Place the image onto a separate part first, and then insert that part into the assy.

 

[hotiron]

CBL
I do not see where mating options are eligible, but importing the picture via Tool, sketch tools, sketch picture... does give positioning options. Thanks