Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
roller expanding SS 304
- Thread starter mielke
- Start date
TJOrlowski
Mechanical
What's the material and thickness of your tube sheet(s)? What's the wall thickness of your tubes?
Do you have a torque-control motor and drive? Do you have any operators experienced with rolling small diameter tubes? Are you roller expanding only, or will you be doing a strength or seal weld in addition?
-TJ Orlowski
Do you have a torque-control motor and drive? Do you have any operators experienced with rolling small diameter tubes? Are you roller expanding only, or will you be doing a strength or seal weld in addition?
-TJ Orlowski
- Thread starter
- #4
- Thread starter
- #6
TJOrlowski
Mechanical
It's been a while since we did any 3/8" tubes, but for small diameter ferrous materials, you usually want about 8% wall reduction in the expanded area (I'm assuming your application is low pressure with that tube sheet thickness). Use a micrometer to check your first couple tubes.
Make sure your mandrel is inserted no more than 1/2" from the front face of the tube sheet. Get an extra set of rollers. The manufacturer/distributor of your expander can give more advice about what you want to use to drive it.
Expand the tubes one hemisphere at a time, and start with the largest bend radius. Don't expand one leg of the u-tube, then it's other leg. Just expand one whole half, then move to the next half.
-TJ Orlowski
Make sure your mandrel is inserted no more than 1/2" from the front face of the tube sheet. Get an extra set of rollers. The manufacturer/distributor of your expander can give more advice about what you want to use to drive it.
Expand the tubes one hemisphere at a time, and start with the largest bend radius. Don't expand one leg of the u-tube, then it's other leg. Just expand one whole half, then move to the next half.
-TJ Orlowski
We always used parallel rollers instead of tapered rollers for such applications.
For such applications our shop people like to use petroleum jelly, either alone or with a little kerosene, for the lubricant. We have also seal welded tubes of your size in thin tubesheets. We did this by trimming the tube ends to the shortest length possible and randomly welding the tubes with the smallest weld possible so there is no straight lines in the weld pattern.
For such applications our shop people like to use petroleum jelly, either alone or with a little kerosene, for the lubricant. We have also seal welded tubes of your size in thin tubesheets. We did this by trimming the tube ends to the shortest length possible and randomly welding the tubes with the smallest weld possible so there is no straight lines in the weld pattern.
EdStainless
Materials
Have you looked at hydraulic expansion? With small tubes it might work better than rolling.
= = = = = = = = = = = = = = = = = = = =
Plymouth Tube
= = = = = = = = = = = = = = = = = = = =
Plymouth Tube
- Status
Similar threads
- Locked
- Question
- Locked
- Question
