Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Riser Clamps

Status
Not open for further replies.
iamreallysam

iamreallysam

Mechanical
Jun 20, 2013
1
I'm designing a rigging clamp for a 30 inch diameter, 40 metre long riser. I have a pretty good idea of how to design it, but I can't find any codes or standards to which it will adhere. Any ideas?

Thanks in advance,

Sam
 
Status
Not open for further replies.

Similar threads

blademaker
  • Locked
  • Question
Static FEA Shaft Analysis: ignore stress riser effects? 1
Replies
10
Views
239
blademaker
blademaker

Part and Inventory Search

Sponsor

Back
Top Bottom