Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Riser Clamps

Status
Not open for further replies.
iamreallysam

iamreallysam

Mechanical
Joined
Jun 20, 2013
Messages
1
Location
GB
I'm designing a rigging clamp for a 30 inch diameter, 40 metre long riser. I have a pretty good idea of how to design it, but I can't find any codes or standards to which it will adhere. Any ideas?

Thanks in advance,

Sam
 
Status
Not open for further replies.

Similar threads

blademaker
  • Locked
  • Question Question
Static FEA Shaft Analysis: ignore stress riser effects?
Replies
10
Views
490
blademaker
blademaker

Part and Inventory Search

Sponsor

Back
Top