Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

RISA Mass Node changes

Status
Not open for further replies.
WBUW

WBUW

Structural
Joined
May 30, 2006
Messages
63
Location
US
I modeled a 5x5 tubular column as plates. I'd like to change it to a 6x6. Is there a fast way to do this without having to change each and every node? Theres alot of nodes...
 
Sort by date Sort by votes
There is a "Scale" feature that will allow you to scale up the size of your struction in 1, 2 or all 3 directions.

Just go to the Main Menu Toolbar and select Modify - Scale...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

JoshPlumSE
  • Question Question
Return to RISA?
Replies
13
Views
23K
JoshPlumSE
JoshPlumSE
JoshPlumSE
  • Locked
  • Question Question
RISA pronounced like Liza or Visa
Replies
3
Views
4K
JoshPlumSE
JoshPlumSE
BoHboH
  • Locked
  • Question Question
Risa 3D to Floor; diaphragm and seismic loads
Replies
11
Views
3K
JoshPlumSE
JoshPlumSE
keen_mentee
  • Locked
  • Question Question
RISA 3D: WLY in LC Generator
Replies
2
Views
1K
WesternJeb
WesternJeb
RattlinBog
  • Locked
  • Helpful tip Helpful tip
Risa-3D - Confirmed error with calculation of hp for singly-symmetric beams AISC 360-16 Sect. F4
Replies
7
Views
4K
JoshPlumSE
JoshPlumSE

Part and Inventory Search

Sponsor

Back
Top