Hello I am running a f1 4020 6000w co2 amada laser I am having issues where after my sharp corners I get ripples on my .25 .38 and .50 hrs steel I have tried the recovery but I am having trouble all my holes are coming out great and after about an inch it smooths back out but it just can't seem to recover anyone have any suggestions out there?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ripples on .25 .38 and .50 hrs steel after a corner
- Thread starter Venom2012
- Start date
Similar threads
- Question
