Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Revision Table Template with Revision 00 filled out 2

Status
Not open for further replies.

RachelYork

Mechanical
Joined
Oct 14, 2010
Messages
2
Location
US
The company I work with uses Revision 00 to 'Release for manufacturing'. I'd like to create a SolidWorks BOM Template with this included as it is standard. When I fill out the revision row and save to a template file, the save excludes the revision 00. Is there a way to save a BOM template with the first revision already filled in?
Thanks!
 
"I'd like to create a SolidWorks BOM Template with this included as it is standard."

"Is there a way to save a BOM template with the first revision already filled in?"

I assume you meant Rev and not BOM

... and to answer your question, No.
 
You can add the rev table to your drawing template, add the row with the revision, then save back the drawing template.
I have mine setup this way.

Chris
SolidWorks 10 SP4.0
ctopher's home
SolidWorks Legion
 
Thank you Chris! I think this will work for us.
 
Chris ... With the rev showing? When I tried it didn't show.

Will try again later.
 
Hmmm ... Worked this time. Must have been a hiccup ... or I did something stupid.

Anyway, good to know.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top