Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

reverse fillet

Status
Not open for further replies.

gib2j

Marine/Ocean
Joined
Oct 20, 2004
Messages
26
Location
GB
is it possible to do a reverse fillet? ie on the inside of a corner of cut plate create a mousehole instead of adding material as a normal fillet will do...
 
Just guessing, but it may need to be a swept profile. 3d sketch a curve if necessary...

I dunno, Im no expert. Never heard of a reverse fillet style operation before, but I suppose having an undercut tool would have its places sometimes!.

I'll leave it to the experts to answer, my guess is no, and a path cut will be required. :)


Sirius2
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top