kemosabe08
Mechanical
- Nov 8, 2023
- 1
Hello I am trying to migrate my V5 robot data to V6.
But while doing it and after opening the robot data in V6,
the robot coordinates are getting changed and I have to manually compare V5 and V6 data
and change the coordinates again. Is there any solution to make sure the corrdinates remain the same?
But while doing it and after opening the robot data in V6,
the robot coordinates are getting changed and I have to manually compare V5 and V6 data
and change the coordinates again. Is there any solution to make sure the corrdinates remain the same?