Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Reset Section increments !

Status
Not open for further replies.
mechy20

mechy20

Mechanical
Joined
Feb 8, 2007
Messages
36
Hi,
How do I reset the default section increments in SW06? I could not find it in options....
Thanks
 
Sort by date Sort by votes
mechy20,

In SW2007 it's located in:

'Tools' -> 'Options' -> (System Options Tab) -> 'Spin Box Increments' -> 'Length Increments'

I assume its in a similar location in 2006.

Good Luck
-Lou
 
Upvote 0 Downvote
Thanks,
It was right in front of my eyes...cannot believe it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Platypusimon
  • Locked
  • Question Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
1K
jassco
jassco
Helepolis
  • Locked
  • Question Question
Assembly Section View - Zonal Section Method is Greyed Out
Replies
1
Views
610
Gupta65
Gupta65
Platypusimon
  • Locked
  • Question Question
MCI of different sections of an assembly
Replies
4
Views
475
jassco
jassco
Sa-Ro
  • Locked
  • Question Question
Section lable
Replies
2
Views
190
CorBlimeyLimey
CorBlimeyLimey
ngkw1
  • Locked
  • Question Question
Changing section view for every new drawing file
Replies
1
Views
211
Jboggs
Jboggs

Part and Inventory Search

Sponsor

Back
Top