Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Requirements for Instrumentation documents to be stamped in Alberta?

Thread starter greg2013
Start date May 22, 2013

Status: Not open for further replies.

May 22, 2013

greg2013

Petroleum

Not sure where to ask this, but I have a question as to whether or not instrumentation documentation requires an engineering stamp in order to be used? I have worked for a few different companies and I have yet to get a straight answer on the need for this. I know P&ID's and C&E documents get stamped, but unsure about stuff like datasheets, Range report, I/O list, Loop Drawings.