Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Required fit for Brazing Shaft through a Hole.

Status
Not open for further replies.
Zibraz

Zibraz

Mechanical
Joined
Feb 23, 2021
Messages
27
Location
GB
What fit would you put when brazing a shaft through a hole?

I believe it's a close clearance fit (Something like a H7 g6) but I just wanted to make sure.
 
Sort by date Sort by votes
It seems the ideal clearance for brazing is 0.001-.005 inch. I believe H7g6 may be a bit tight on smaller shaft diameters.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

joshcarr22
  • Locked
  • Question Question
Shaft sleeve or bushing assembly for composite shaft
Replies
2
Views
910
joshcarr22
joshcarr22
p6g2p6
  • Locked
  • Question Question
Literature for vertical shaft journal bearings
Replies
2
Views
4K
p6g2p6
p6g2p6
eliam
  • Locked
  • Question Question
Bearing stress on a rectangular shape on shaft coupling
Replies
5
Views
1K
Tmoose
Tmoose
Wkcoo
  • Locked
  • Question Question
Bronze oil ring polishing out shaft / sleeve?
Replies
2
Views
864
Compositepro
Compositepro
see_gen_notes
  • Locked
  • Question Question
Force Required to Open a Heavy Door
Replies
1
Views
721
Stick.
Stick.

Part and Inventory Search

Sponsor

Back
Top