mash98
Electrical
- Jul 17, 2008
- 56
Dear all we have a separately exited dc motor in our bar rolling mill with following nameplate in formations.
The nameplate of finish mill Dc motor is as follows:
General Electric
Direct current motor
No. 2321820
Type MCF
HP 1250
RPM 500/910
Form_______
Volt 600
Amp 1632
Exc Volt 250
Wound______
Commutator 55 degree celcius
Insulation winding and Armature core 40 degree celecius
Bare copper winding 50 degree celcius
Shunt Field 50 degree celcius
Below 625 RPM
Ventilating Air 7000 CFM
CAUTION: Before insulating or operating read instructions GEH-709
Schenectacly NY MAde in USA
Can anybody help me in getting the source from where I can obtain the details informations of this motor? like duty (although it seems continuous as it is externally forced cooled), Tolerence in field voltage etc.
Thanking in anticipation.
The nameplate of finish mill Dc motor is as follows:
General Electric
Direct current motor
No. 2321820
Type MCF
HP 1250
RPM 500/910
Form_______
Volt 600
Amp 1632
Exc Volt 250
Wound______
Commutator 55 degree celcius
Insulation winding and Armature core 40 degree celecius
Bare copper winding 50 degree celcius
Shunt Field 50 degree celcius
Below 625 RPM
Ventilating Air 7000 CFM
CAUTION: Before insulating or operating read instructions GEH-709
Schenectacly NY MAde in USA
Can anybody help me in getting the source from where I can obtain the details informations of this motor? like duty (although it seems continuous as it is externally forced cooled), Tolerence in field voltage etc.
Thanking in anticipation.