Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Replace link in drawing 1
- Thread starter CAD2015
- Start date
-
1
- #2
Hi,
Search on Google for "Replace link in CATIA drawing", you will get a lot of answers about your problem.
Regards
Fernando
Search on Google for "Replace link in CATIA drawing", you will get a lot of answers about your problem.
Regards
Fernando
Hi ,
You cannot replace the drawing of a 3D with any 3D. For this you should have a same copy of the current 3D which is saved by using the option "save as " . Because CATIA uses the identification no called as UUID (unique Identifier ) for each file. The UUID of the drawing and the part should match with each other. hOPE IT HELPS.
You cannot replace the drawing of a 3D with any 3D. For this you should have a same copy of the current 3D which is saved by using the option "save as " . Because CATIA uses the identification no called as UUID (unique Identifier ) for each file. The UUID of the drawing and the part should match with each other. hOPE IT HELPS.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
