Remove dimension line

[cubalibre000]

Hi,
it's possible ti remove the dimension line indicated by the image attached ?

Thank you...

Using NX 8 and TC9.1

 

[cowski]

Use the radius rather than radius to center dimension type.

www.nxjournaling.com

 

[SDETERS]

Has this drawing been translated from I-deas to NX using CMM?

 

[cubalibre000]

Then I need to delete them and create again ?
Interesting.
Anyway...thank you a lot.

P.S.This drawing is native NX.

Thank you...

Using NX 8 and TC9.1

 

[JohnRBaker]

The original dimension 'type' was inappropriate. You have no choice but to delete it and create a new, PROPER dimension.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.