Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Remote Communication

Status
Not open for further replies.
phantompremium

phantompremium

Bioengineer
May 22, 2007
1
Hello everyone,

I have two Simulink models on two seperate computers. I would like to run both through one computer, is there a way to do this? I cannot change the transport layer as it is used to communicate with haptic devices.

So my question is, is there a way in MATLAB or Simulink where I can open, connect to target and run a Simulink diagram on another computer.

Thanks in advance!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom